Grand Cherokee 4WD V8-4.7L Flex Fuel (2009)
Accelerator Pedal: Service and Repair
Installation
INSTALLATION
Without APPS (Accelerator Pedal Position Sensor)
The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles not equipped with an
accelerator pedal position sensor.
The accelerator pedal is serviced as a complete assembly including the bracket.
1. Place accelerator pedal assembly (2) over two mounting studs (1).
2. Install and tighten two mounting nuts (3). Refer to Torque Specifications.
3. Slide throttle cable into opening slot in top of pedal arm.
4. Push plastic cable retainer (clip) (2) into accelerator pedal arm opening until it snaps into place.
5. Before starting engine, operate accelerator pedal to check for any binding.
With APPS (Accelerator Pedal Position Sensor)
