Grand Cherokee 4WD V8-4.7L Flex Fuel (2009)
Brake Light Switch: Description and Operation
Stop Lamp Switch - Operation
OPERATION
The brake lamp switch controls three independent circuits. These circuits are described as follows:
-
Brake Lamp Switch Circuit - A normally open brake lamp switch circuit receives a battery voltage input, and supplies this battery voltage to the
brake lamps and the Controller Antilock Brake (CAB) on a brake lamp switch output circuit only when the brake pedal is depressed (brake lamp
switch plunger released).
-
Brake Lamp Switch Signal Circuit - A normally closed brake lamp switch signal circuit receives a direct path to ground, and supplies this
ground input to the Powertrain Control Module (PCM) on a brake lamp switch sense circuit only when the brake pedal is released (brake lamp
switch plunger is depressed).
-
Speed Control Circuit - A normally closed speed control circuit receives a battery voltage input from the PCM on a speed control supply circuit,
and supplies this battery voltage to the speed control servo solenoids (dump, vacuum, and vent) on a speed control brake switch output circuit only
when the speed control system is turned ON and the brake pedal is released (brake lamp switch plunger is depressed).
The brake lamp switch as well as the hard wired inputs and outputs of the switch may be diagnosed using conventional diagnostic tools and procedures.
Refer to the appropriate wiring information.
