Grand Cherokee 4WD V8-4.7L Flex Fuel (2009)
6. Install the outer tie rod end to the steering knuckle. See: Steering/Tie Rod/Tie Rod End/Service and Repair/Removal and Replacement/Tie Rod
End - Installation.
7. Install the hub/bearing (3), Tighten to 115 Nm (85 ft.lbs.). See: Wheel Bearing/Service and Repair/Front Hub and Bearing - Installation.
8. Install the axle shaft nut. Tighten the nut to 135 Nm (96 ft.lbs.).(if equipped with four wheel drive).
NOTE: Check the sensor wire routing (1). Be sure the wire is clear of all chassis components and is not twisted or kinked at any spot.
9. Install the wheel speed sensor (1) into the hub (3) and then install the mounting bolt (2) and tighten to 12-14 Nm (106-124 in. lbs.).See: Brakes
and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed Sensor/Service and Repair/Wheel Speed Sensor -
Installation/Front.
