Grand Cherokee 4WD V8-4.7L Flex Fuel (2009)
1. Install a new rear output shaft seal into the rear cover with Installer 6952A.
2. Install the rear output shaft flange (1) onto the output shaft (2).
3. Using Holder C-3281 (1), install the rear companion flange (2) nut. Tighten the bolts to 122-176 Nm (90-130 ft.lbs.).
4. Install the rear propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement/Drive Shaft - Removal
5. Check the transfer case fluid level. See: Fluid - Transfer Case/Service and Repair/NV146 Transfer Case Correct as necessary.
