Grand Cherokee 4WD V8-4.7L VIN N (2000)
Sun Shade: Service and Repair
REMOVAL
1. Open sunroof approximately 50% of the way.
2. Push sunshade down until tabs clear glass.
3. Move sunshade forward of glass panel.
4. Compress the spring loaded plungers holding the guide blocks in the track.
5. Slide the sunshade forward while lifting the front through the opening until the rear guide blocks are accessible.
CAUTION: Use care not to crease the sunshade when removing or installing.
6. Disengage rear guide blocks from track.
INSTALLATION
1. Install the sunshade from outside of the vehicle with the sunroof fully open.
2. Put rear guide blocks into sunshade guide track.
3. Push sunshade back and down through the sunroof opening.
4. Using a flat blade tool, put front guide blocks into the sunshade track. By pushing the block towards the center of the vehicle.
5. Move the glass panel to approximately halfway to the fully closed position.
6. Push sunshade down until the sunshade clears the glass then move sunshade rearward behind the glass panel.
