Grand Cherokee 4WD V8-4.7L VIN N (2000)
Power Seat Switch: Service and Repair
Memory Switch Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the driver side front door.
3. Disconnect the memory switch wire harness connector from the driver door module connector receptacle.
4. Remove the two screws that secure the memory switch to the back of the driver side front door trim panel.
5. Remove the memory switch from the back of the driver side front door trim panel.
INSTALLATION
1. Position the memory switch onto the back of the driver side front door trim panel.
2. Install and tighten the two screws that secure the memory switch to the back of the driver side front door trim panel. Tighten the screws to 2.2 Nm
(20 in. lbs.).
3. Reconnect the memory switch wire harness connector to the driver door module connector receptacle.
4. Install the trim panel onto the driver side front door.
5. Reconnect the battery negative cable.
