Grand Cherokee 4WD V8-4.7L VIN N (2000)
13. Push the cable in and lift up the end of cable with a small screw driver to disengage the cable from the parking brake actuator.
14. Remove the cable from the vehicle.
INSTALLATION
1. Install the cables through the caliper anchor mount. Then push the end of cable strand in to engage the cable end to the parking brake actuator.
2. Feed the other end of the cables through the body and into the equalizer bracket.
3. Push the cables into the upper suspension arm brackets.
4. Install the cable retainer bolts to the rear spring pads.
5. Install the ABS sensor wiring harness to the rear brake cables.
6. Install the rotors, caliper anchors and brake calipers.
7. Install the wheel and tire assemblies.
8. Remove support and lower the vehicle.
9. Engage the cable ends into the parking brake equalizer.
10. Pull on the lever to release the lock out spring.
11. Install center console.
12. Fold down the rear carpet cover and rear seat.
13. Verify parking brake operation.
