Grand Cherokee 4WD V8-4.7L VIN N (2000)
Parking Brake Lever: Service and Repair
REMOVAL
1. Remove center console.
2. Lift up rear seat and carpet covering the parking brake cables.
3. Place a screw driver through the front cable eyelet and pry back on the front cable.
4. Have an assistant pry down the lock out spring through the hole in the side of the park brake lever with a small screw driver. Then slowly release
the front cable.
NOTE: There should be slack in the cable if the lock out spring is engaged.
5. Disconnect parking brake switch wiring connector.
6. Disengage front cable end from parking brake lever.