Grand Cherokee 4WD V8-4.7L VIN N (2000)
Service Procedure For LH Vehicles
Service Procedure for LH Vehicles
1.
With the ignition key in the OFF position, disconnect the negative battery cable.
Note:
To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.
2.
Remove the four (4) screws that attach the glove box door to the instrument panel (I/P) and remove the glove box door.
FIGURE 1
3.
Remove the right I/P end cap (Figure 1).
4.
For vehicles equipped with a center console only:
a.
Remove the gearshift handle set screw and then remove the gearshift handle.
b.
Remove the console shifter bezel.
c.
Remove the right console side trim panel.
5.
Remove the right lower I/P trim panel/glove box compartment.
6.
Remove the right and left A-Pillar trim panels.
7.
Remove the upper I/P cover (Figure 1).
8.
Remove the left I/P end cap (Figure 1).
9.
Remove the left lower I/P cover (Figure 1). Disconnect the hood release cable and trunk release electrical connector and set the cover aside.
10.
Remove the left knee blocker.
11.
Remove the I/P center bezel. Disconnect the heater control and traction control (if equipped) electrical connectors and set the bezel aside.
12.
For vehicles equipped with a center console only: Remove the left console side trim panel.
13.
For vehicles equipped with a center console only: Remove the console to I/P center support bracket.
