Grand Cherokee 4WD V8-4.7L VIN N (2000)
Acceleration/Deceleration Sensor: Service and Repair
REMOVAL
1. Fold the rear seat bottom assembly up for access to the switch.
2. Lift up the carpeting and disconnect switch harness.
3. Remove the switch mounting bolts and remove the switch.
INSTALLATION
CAUTION: The mercury switch (inside the G-Switch), will not function properly if the switch is installed incorrectly. Verify that the switch locating
arrow is pointing to the front of the vehicle.
1. Note position of locating arrow on switch. Position switch so arrow faces forward.
2. Install the switch and tighten mounting bolts to 5.6 Nm (50 inch lbs.).
3. Connect harness to switch. Be sure harness connector is firmly seated.
4. Place the carpet in position and fold the rear seat back down.
