Grand Cherokee 4WD V8-4.7L VIN N (2000)
Valve Body: Service and Repair
Solenoid Body
Disassembly and Assembly
For further information Regarding this Component or the system it is a part of please refer to Automatic Transmission/Transaxle; Service and Repair.
Removal and Installation
REMOVAL
Fig. 42
1. Remove the valve body from the transmission (Fig. 42).
Fig. 43
2. Remove the screws holding the solenoid and pressure switch assembly onto the valve body (Fig. 43).
3. Separate the solenoid and pressure switch assembly from the valve body.
INSTALLATION
1. Place TRS selector plate in the PARK position.
2. Position the solenoid and pressure switch assembly onto the valve body. Be sure that both alignment dowels are fully seated in the valve body and
that the TRS switch contacts are properly positioned in the selector plate
3. Install the screws to hold the solenoid and pressure switch assembly onto the valve body.
4. Tighten the solenoid assembly screws adjacent to the arrows cast into the bottom of the valve body first. Tighten the screws to 5.7 Nm (50 inch
