Grand Cherokee 4WD V8-5.2L VIN Y (1998)
Speaker: Service and Repair
Sound Bar 1
REMOVAL
1. Disconnect and isolate the battery negative cable.
Sound Bar Remove/Install
2. Gently pry at the perimeter edges of each of the two snap-fit screw covers located on each end of the sound bar to uncover the screw heads.
3. Remove the four screws that secure each end of the sound bar to the rear roof rail reinforcements.
4. Use a straight-bladed screw driver to unscrew the push nut that secures the center of the sound bar to the sound bar bracket stud.
5. Lower the sound bar far enough to access and unplug the wire harness connector near the right end of the sound bar.
6. Remove the sound bar from the vehicle.
7. Reverse the removal procedures to install. When installing the sound bar, push the push nut through the center sound bar mounting hole onto the
mounting stud using finger pressure. Be certain that a spacer is in place on each of the four mounting screws between the sound bar and the rear
roof rail reinforcements. Tighten the mounting screws to 1.7 N.m (15 in. lbs.).
