jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Recall - Power Brake Booster|Page 5651 > < Recall - Power Brake Booster|Page 5649
Page 4
background image

13.

In the engine compartment, slide the booster forward, tilt it upwards slightly and then remove it from the engine compartment.

14.

Remove the dash panel seal from the brake booster.

15.

Install the dash panel seal on the new brake booster.

16.

Install the new brake booster into position on the dash panel.

17.

Inside of the vehicle, lubricate the brake pedal pin and bushing with Mopar multi-mileage grease or equivalent.

18.

Loosely install the four (4) brake booster attaching nuts (Figure 4).

19.

Slide the booster push rod over the pedal pin. Secure the push rod with the provided retainer clip (Figure 3).

20.

Tighten the four (4) brake booster attaching nuts to 29 ft-lbs (39 N.m).

21.

Adjust the brake switch by pulling up on the brake pedal as far as it will go. A racheting noise from the brake switch is considered normal.

22.

For Cherokee (XJ) vehicles, install the knee blocker and lower steering column cover.

23.

In the engine compartment, connect the vacuum hose to the brake booster.

24.

Install the master cylinder onto the new brake booster (Figure 2). Tighten the attaching nuts to 155 in-lbs (18 N.m).

25.

Install the combination valve onto the new brake booster (Figure 2). Tighten the attaching nuts to 155 in-lbs (18 N.m).

26.

For Cherokee (XJ) vehicles equipped with ABS, tighten the three (3) ABS HCU bracket fasteners securely.

27.

For Cherokee (XJ) vehicles, install the air filter housing cover.

28.

For Wrangler (TJ) vehicles, install the evaporative canister and bracket assembly.

29.

For Grand Cherokee (ZJ) vehicles, connect the crankcase ventilation system hose to the air filter housing cover.

30.

Connect the negative battery cable.

Completion Reporting and Reimbursement

Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service c

Use one of the following labor operation numbers and time allowances:

Labor Operation

Time

Number

Allowance

^

Inspect brake booster date code

05764181

0.2 hours

^

Inspect brake booster date code and replace power brake booster

^

Grand Cherokee (ZJ) and Wrangler (TJ)

05764182

0.4 hours

^

Cherokee (XJ)

05764183

0.7 hours

Add the cost of the recall parts package plus applicable dealer allowance to your claim.

Note:

See the Warranty Administration Manual, Recall Claim Processing Section for complete recall claim processing instructions.

Parts Return and Vehicle Not Available

Parts Return

Not required.

Vehicle Not Available

If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Notification Form or describe the reason on a postcard and mail to:

Recall - Power Brake Booster|Page 5651 > < Recall - Power Brake Booster|Page 5649