Grand Cherokee 4WD V8-5.2L VIN Y (1998)
Throttle Cable/Linkage: Service and Repair
THROTTLE CABLE REMOVAL
1. From inside the vehicle, hold up accelerator pedal. Remove plastic cable retainer (clip) and throttle cable core wire from upper end of pedal arm
(Fig. 40). Plastic cable retainer (clip) snaps into pedal arm.
2. Remove the cable core wire at pedal arm.
3. From inside the vehicle, pinch both sides of the cable housing retainer tabs (Fig. 40). at the dash panel. Remove cable housing from dash panel
and pull into the engine compartment.
Fig. 43 Throttle Cable At Throttle Body
4. Remove the throttle cable ball end socket at throttle body linkage (Fig. 43) (snaps off).
