Grand Cherokee 4WD V8-5.2L VIN Y (1998)
Check Pinion Gear Rotation Torque
11. Slowly tighten the nut in 6.8 Nm (5 ft. lbs.) increments until the rotating torque is achieved. Measure the rotating torque frequently to avoid over
crushing the collapsible spacer.
12. Check bearing rotating torque with an inch pound torque wrench. The torque necessary to rotate the pinion gear should be:
-
Original Bearings - 1 to 3 Nm (10 to 20 inch lbs.).
-
New Bearings - 2 to 5 Nm (15 to 35 inch lbs.).
13. Align previously made marks on yoke and propeller shaft and install propeller shaft.
14. Install differential housing into the axle housing.
