Grand Cherokee 4WD V8-5.7L (2008)
Front Door Window Regulator: Service and Repair
Front Door Window Regulator - Installation
INSTALLATION
1. Load the window regulator (3) into the front door through the large access hole in the center of the door and connect the wire harness connector
(4) to the regulator motor.
2. Engage the glass into regulator clamps.
3. Install the bolts (1 and 2) that secure the regulator rails to the door. Tighten the bolts to 8.5 Nm (75 in. lbs.).
4. Carefully remove the tape securing the door glass in its full up position.
5. Temporarily install the window switch and raise the glass into the full up position.
6. Tighten the bolts in each of the window regulator glass clamps to 12 Nm (105 in. lbs.).
7. Install the watershield and the trim panel onto the inside of the front door. See: Front Door Panel/Service and Repair/Front Door
Watershield/Installation
