Grand Cherokee 4WD V8-5.7L (2008)
Seat Heater: Service and Repair
Heated Seat Element - Removal
REMOVAL
NOTE: Seat back heated seat element shown, seat cushions similar.
NOTE: Do not remove the factory installed heating elements from the seat or seat back cushions. The original element is permanently attached
and cannot be removed without permanent damage. The replacement heating element is designed to be applied directly on top of the factory
installed heating element.
1. Disconnect and isolate the battery negative cable.
2. Remove the appropriate seat cushion or seat back trim cover (1). Refer to the appropriate procedures in section 23 - BODY/SEATS.
3. Disconnect the inoperative heated seat cushion or seat back element electrical connectors.
4. Locate the wires leading from the inoperative heating element (2) and cut them off flush with the edge of the original heating element (3).
