jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Antenna Cable - Satellite Radio|Page 10473 > < Antenna Cable - Satellite Radio|Page 10471
Page 2
background image

7. Remove the antenna retaining straps and remove antenna cable (4).

EXPORT

WARNING:  Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag, or instrument
panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible personal injury.

1. Disconnect and isolate the battery negative cable.

2. Remove the instrument panel.

CAUTION:  Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable
or radio.

3. Disconnect the antenna cable by pulling the locking antenna connector (2) away from the radio (1).

4. Disengage each of the retainers that secure the cable (2) to the instrument panel and remove cable.

Installation

INSTALLATION

Antenna Cable - Satellite Radio|Page 10473 > < Antenna Cable - Satellite Radio|Page 10471