Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
Brake Pad: Procedures
BRAKE PAD BURNISHING
CAUTION: After installing NEW brake pads, keep in mind that braking effectiveness might be somewhat reduced during the first brake
applications.
When NEW brake pads are installed on a vehicle, this procedure must be used to correctly burnish (seat) the brake linings to the brake rotor discs.
1. Accelerate the vehicle to a steady speed of about 40 mph (65 km/h).
2. Using light brake pedal pressure, slow the vehicle from 40 mph to 0 mph in approximately 6 seconds.
3. Accelerate back up to 40 mph for approximately one minute to allow the brakes to cool down.
4. Repeat this procedure 15 to 20 times to correctly seat the brake lining material.