Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
7. Disconnect and isolate the negative battery cable.
8. Remove the instrument panel from the vehicle.
9. Remove the two screws (1) that secure the mode door actuator (2) to the rear of the HVAC air distribution housing (3).
10. Remove the mode door actuator from the air distribution housing and disconnect the HVAC wire harness connector (4) from the actuator.
11. Remove the mode door actuator from the vehicle.
Installation
INSTALLATION
PANEL/DEFROST/DEMIST/FLOOR
1. Position the mode door actuator (1) into the vehicle.
2. Install the mode door actuator onto the left side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (3) with those on the mode door cam (4).
