Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
Power Distribution Module: Service and Repair
Installation
INSTALLATION
NOTE: If replacing the Integrated Power Module (IPM) (1) with a new assembly it will be necessary to transfer the circuit protection devices as well as
the Front Control Module to the new IPM.
1. Position the IPM into the vehicle.
2. Connect the two Front Control Module (FCM) connectors (5).
3. Connect the two IPM connectors (4).
4. Position the IPM over the three bracket tabs (2) and apply downward pressure until the retaining clips snap into place securely.
5. Install the battery positive cable (3) to the IPM B+ terminal stud.
6. Install the nut (2) to the IPM B+ terminal stud. Tighten the nut to 11.5 Nm (105 in. lbs.).
7. Close the IPM cover ensuring the locking tabs snap firmly in place.
8. Connect the battery negative cable.
