Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
5. Remove the screw (3) that secures the seat belt turning loop (4) to the height adjuster (10).
6. Remove the seat belt turning loop from the height adjuster.
7. Remove the upper trim from the inside of the B-pillar (9).
8. Unsnap and remove the cover (5) from above the seat belt opening in the B-pillar trim (2).
9. Remove the trim from the lower B-pillar.
10. Pull the front seat belt turning loop and lower anchor through the seat belt opening in the lower B-pillar trim.
11. Remove the screw (7) that secures the retractor (6) lower bracket to the base of the inner B-pillar.
12. Remove the front seat belt and retractor from the vehicle as a unit.
Rear Center
REAR CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
