Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
Alternator Pulley: Service and Repair
Installation
INSTALLATION
INA Decoupler
1. Thread decoupler pulley onto generator shaft by hand (right-hand threads).
2. Position Special Tool #8823 (VM.1048) into decoupler.
3. Determine if end of generator shaft is hex shaped or is splined. If hex is used, insert a 10MM deep socket (1) into tool #8823 (VM.1048)
or..............
4. ............if splined, insert a 5/16, 6-point hex driver (1), or a 10MM 12-point triple square driver into tool #8823 (VM.1048).
5. Do not use an adjustable, ratcheting "click type" torque wrench. Most "click type" wrenches will only allow torque to be applied in a clockwise
rotation. Use a dial-type or beam-type wrench. Tighten in counter-clockwise rotation. Torque to 80 Nm (59 ft. lbs.).
6. Install accessory drive belt, and generator. Refer to Generator Installation.
7. Connect negative battery cable.
Litens Decoupler
