Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
3. Remove the transmission fill tube bolts (2).
4. Lift the transmission fill tube out of the transmission case.
5. Using a small pry tool remove the transmission fill tube seal.
Installation
INSTALLATION
1. Pierce the new transmission fill tube seal along the molded "Y" from the outside.
NOTE: If the new fill tube seal can not be fully installed into the transmission case fill tube bore by hand, a "C" clamp must be used.
CAUTION: Do not over tighten the "C" clamp during fill tube oil seal installation. Transmission oil pan damage or bending may occur.
