Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
NOTE: Removing and re-indexing the propeller shaft 90° rear axle 45° trans case or front axle relative to the yoke may eliminate some
vibrations.
If propeller shaft is suspected of being unbalanced, it can be verified with the following procedure:
1. Raise the vehicle.
2. Clean all the foreign material from the propeller shaft and the universal joints.
3. Inspect the propeller shaft for missing balance weights, broken welds, and bent areas.
4. Inspect the universal joints to ensure that they are not worn, are properly installed, and are correctly aligned with the shaft.
5. Check the universal joint flange screws torque.
6. Remove the wheels and tires. Install the wheel lug nuts to retain the brake drums or rotors.
7. Mark and number the shaft six inches from the yoke end at four positions 90° or 45° apart depending on flange.
8. Run and accelerate the vehicle until vibration occurs. Note the intensity and speed the vibration occurred. Stop the engine.
9. Install a screw clamp (1) at position 1.
10. Start the engine and re-check for vibration. If there is little or no change in vibration, move the clamp to one of the other three positions. Repeat
the vibration test.
11. If there is no difference in vibration at the other positions, the source of the vibration may not be propeller shaft.
12. If the vibration decreased, install a second clamp (1) on the shaft (2) and repeat the test.
