Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
NOTE: ...and the transfer case drive spline (1) missing tooth (2) are aligned. It may be necessary to manually shift the transfer case if the
shift motor and transfer case shaft are not aligned.
2. Position the shift motor (1) onto the transfer case (3) and shift sector (2).
3. Install the bolts (1) to hold the shift motor (2) onto the transfer case. Tighten the bolts to 25-28 Nm (18.5-20.5 ft.lbs.).
CAUTION: If the original shift motor are reused, be sure to use Mopar(R) Lock & Seal or Loctite(TM) 242 to replenish the lock patch
material originally found on the bolts
4. Engage the wiring connector to the shift motor.
5. Lower vehicle and verify transfer case operation.
