Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
Seals and Gaskets: Service and Repair
NV146 Transfer Case
Seal-Front Output Shaft
REMOVAL
The front output shaft seal and wear sleeve cannot be serviced in the vehicle. The transfer case must be disassembled to remove the front output shaft
assembly and seal.
Removal
REMOVAL
1. Remove the rear propeller shaft.
2. Using Holder C-3281 (1), remove the rear companion flange (2) nut.
3. Remove the rear output shaft flange (1) from the output shaft (2). If necessary, use a suitable 2 or 3 jaw puller to remove the output shaft flange.
4. Remove the rear output shaft seal with a suitable pry tool or a screw mounted in a slide hammer.
Installation
INSTALLATION
