Grand Cherokee 4WD Laredo V8-4.7L (2002)
3. Align the two front latch features of the ITM with the two front latch receptacles of the mounting bracket above the headliner.
4. Push the ITM trim cover forward far enough to insert the two rear latch features of the module into the two rear latch receptacles of the mounting
bracket above the headliner.
5. Push upward firmly and evenly on the rear edge of the ITM trim cover until the two rear latch features of the module are engaged and latched in
the mounting bracket above the headliner.
6. Reconnect the battery negative cable.
NOTE: If the Intrusion Transceiver Module (ITM) has been replaced with a new unit, the new ITM MUST be initialized before the Vehicle Theft
Security System can operate as designed. The use of a DRB III scan tool is required to initialize the ITM. Refer to the appropriate diagnostic
information.
