Grand Cherokee 4WD Laredo V8-4.7L (2002)
Fig. 6
3. Un-clip forward leg of quarter panel trim and position aside as necessary. (Fig. 6)
4. Grasp upper c-pillar trim at lower edge and pull outward then down to detach from c-pillar.
5. Route rear shoulder belt through access hole.
6. Separate c-pillar upper trim from vehicle.
INSTALLATION
1. Position c-pillar upper trim at c-pillar. (Fig. 6)
2. Route rear shoulder belt through access hole.
3. Press upper edge of c-pillar upper trim onto c-pillar and slide up into place onto the upper hook fasteners.
4. Seat the lower edge clip fully.
5. Press quarter panel trim into place as necessary.
6. Ensure front edge of trim is covered by weatherstrip.
7. Position the rear outboard seat belt lower anchor to the rear floor panel. (Fig. 5)
8. Install screw that secures the rear outboard seat belt lower anchor to the rear floor panel and tighten to 43 N.m (32 ft. lbs.).
D-Pillar Trim
D-PILLAR TRIM
REMOVAL
