Grand Cherokee 4WD Laredo V8-4.7L (2002)
Brake Master Cylinder: Service and Repair
Fluid Reservoir Removal and Installation
FLUID RESERVOIR
REMOVAL
1. Remove reservoir cap and remove fluid with a clean suction gun.
2. Remove the wire connector from the brake fluid level sensor.
Release Tool
3. Insert the tool provided with the reservoir to release the reservoir retaining tabs.
4. Pull the reservoir straight up out of the cylinder.
5. Remove and discard grommets from the cylinder body.
INSTALLATION
1. Lubricate new grommets with clean brake fluid. Install new grommets into the cylinder body.
CAUTION: Do not use tools to install the grommets. Tools may cut, or tear the grommets. Install the grommets using finger pressure only.
2. Start reservoir in grommets then press the reservoir straight down to seat the reservoir into the cylinder grommets.
CAUTION: Do not rock the reservoir during installation.
3. Verify retaining tabs are seated.
4. Install the wire connector to the brake fluid level sensor.
5. Fill master cylinder.
