Grand Cherokee 4WD Laredo V8-4.7L (2002)
30.
Wrap the connector in the center of jumper harness with foam tape (Figure 9).
NOTE:
Do NOT cover label that is attached to the jumper harness.
31.
Wrap the jumper harness-to-instrument panel wiring harness connector with foam tape (Figure 9).
32.
Stuff the jumper harness and connectors into the pocket between the passenger airbag and the instillment panel outlet duct. Secure the connectors
to the instrument panel structural duct with foam tape (Figure 9).
NOTE:
To prevent customer I/P rattle complaints, jumper harness connectors must be wrapped with foam tape and secured to the structural duct.
33.
Install the I/P top pad.
34.
Connect the defroster duct clips to the I/P top pad and install the I/P top pad screws (5) and nuts (4).
35.
Install the I/P ultra light sensor (if equipped) (Figure 1).
36.
Connect the I/P speaker electrical connectors and harness clips.
37.
Install the screw above the radio location that secures the center of the I/P top pad.
38.
Install the right side I/P top pad screws (3) and bolts (2).
39.
Install the right I/P end cap to the top pad and glove box opening (Figure 5). Tighten the screws securely.
40.
Install the lower right center bezel (Figure 6). Tighten the screws that secure it to the I/P glove box opening securely.
41.
Install the glove box door.
42.
Install the center floor tunnel bracket and then install the two (2) screws that secure the I/P to the bracket (Figure 3).
43.
Install the two (2) nuts that secure the center floor tunnel bracket to the transmission tunnel (Figure 3).
44.
Install the left side I/P top pad screws (2).
45.
Install the I/P cluster.
46.
Install the steering column opening cover (Figure 2).
47.
In stall the I/P cluster bezel.
