Grand Cherokee 4WD Laredo V8-4.7L (2002)
Fig.28 Turning Loop Cover Remove/Install
5. Using a trim stick or another suitable wide flat-bladed tool, gently pry the top of the turning loop trim cover to unsnap it from the height adjuster
and access the screw that secures the front seat belt turning loop to the adjuster on the upper B-pillar.
6. Remove the screw that secures the seat belt turning loop to the height adjuster on the upper B-pillar.
7. Remove the seat belt turning loop from the height adjuster.
8. Remove the trim from the lower B-pillar.
9. Pull the front seat belt turning loop and lower anchor through the access hole in the lower B-pillar trim.
Fig.21 Front Retractor
10. Remove the plastic push-in fastener that secures the retractor to the lower B-pillar.
11. Disengage the retractor locator tab from the slot in the B-pillar.
12. Remove the front seat belt and retractor from the B-pillar as a unit.
INSTALLATION
WARNING: DURING AND FOLLOWING ANY SEAT BELT SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES,
MOUNTING HARDWARE, AND RETRACTORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY
BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS.
REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS
A BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE. NEVER ATTEMPT TO REPAIR A SEAT BELT COMPONENT.
ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT COMPONENTS WITH THE CORRECT, NEW AND UNUSED
