Grand Cherokee 4WD Laredo V8-4.7L (2002)
REPLACEMENT PARTS LISTED IN THE MOPAR PARTS CATALOG.
1. Be certain that the retractor shield is properly installed in the lower B-pillar and in good condition before reinstalling the retractor.
2. Position the front seat belt and retractor to the B-pillar as a unit. Be certain to engage the retractor locator tab in the slot in the lower B-pillar.
3. Using hand pressure, install the plastic push-in fastener that secures the retractor to the lower B-pillar.
4. Push the seat belt lower anchor and turning loop through the access hole in the lower B-pillar trim.
5. Reinstall the trim onto the lower B-pillar.
6. Position the seat belt turning loop onto the height adjuster on the upper B-pillar.
7. Install and tighten the screw that secures the seat belt turning loop to the height adjuster. Tighten the screw to 37 Nm (27 ft. lbs.).
8. Using hand pressure, press the top of the turning loop trim cover to snap it onto the height adjuster and cover the screw that secures the front seat
belt turning loop to the adjuster on the upper B-pillar.
9. Position the front seat belt lower anchor to the lower B-pillar.
10. Install and tighten the screw that secures the seat belt lower anchor to the B-pillar. Tighten the screw to 37 Nm (27 ft. lbs.).
11. Pull down the cover over the front seat belt lower anchor far enough to conceal the screw.
12. Reconnect the battery negative cable.
