Grand Cherokee 4WD Laredo V8-4.7L (2002)
2. Remove stub shaft housing bolts.
3. Remove housing from the steering gear.
4. Remove stub shaft housing O-rings.
INSTALLATION
NOTE: If stub shaft housing, seal or bearing is damaged the housing must be replaced.
1. Grease stub shaft seal with special grease supplied with new stub shaft housing.
2. Install new stub shaft housing O-rings.
3. Install housing on the steering gear.
4. Install the housing bolts and tighten to 62 Nm ( 46 ft. lbs.).
5. Install the steering gear.
6. Fill the power steering pump.
