Grand Cherokee 4WD Laredo V8-4.7L (2002)
Lateral Stabilizer Rod: Service and Repair
REMOVAL
1. Raise and support the vehicle.
2. Remove the nut and bolt from the frame rail bracket.
3. Remove the bolt from the axle shaft tube bracket. Remove the track bar.
INSTALLATION
1. Install the track bar to the axle tube bracket. Install the retaining bolt finger tight.
2. Install track bar to the frame rail bracket. Install the bolt and nut finger tight.
NOTE: It may be necessary to pry the axle assembly over to install the track bar to the frame rail bracket.
3. Remove the supports and lower the vehicle.
4. With the vehicle on the ground tighten the nut at the frame rail bracket and to the bolt at the axle bracket to 100 Nm (74 ft. lbs.).
5. Check alignment specifications if a new track bar was installed.
