jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Body - Sunroof Glass Not Flush With Roof/Won't Close|Page 160 > < Body - Sunroof Glass Not Flush With Roof/Won't Close|Page 158
Page 1
background image

Sunroof / Moonroof Module: Service and Repair

REMOVAL

WARNING:  THE EXCESSIVE FORCE LIMITATION (EFL) FEATURE MUST BE CALIBRATED ANY TIME A SUNROOF
MOTOR/MODULE IS REPLACED WITH A NEW COMPONENT. FAILURE TO PERFORM THIS PROCEDURE COULD RESULT IN
VEHICLE DAMAGE AND/OR PERSONAL INJURY.

1. Move glass panel to the fully closed position.
2. Disconnect and isolate the battery negative cable.
3. Remove headliner.
4. Disconnect the sunroof wire harness electrical connector (2) and separate the harness support clips (1) from the body.

5. Disconnect the front (1) and rear (2) drain tubes from sunroof housing.

Body - Sunroof Glass Not Flush With Roof/Won't Close|Page 160 > < Body - Sunroof Glass Not Flush With Roof/Won't Close|Page 158