Grand Wagoneer V8-360 5.9L VIN 7 2-bbl (1989)
3.
Use a flat blade screwdriver to lift up on the rear lip of the reservoir, (Figure 20). Use the back of the mounting bracket as a pivot point.
4.
Lift and rock the reservoir, pulling it free from the actuator and grommets.
5.
Remove and discard the grommets from the actuator housing.
6.
Remove the bolt from the inboard face of the accumulator block which secures the plastic coated "P"-clip, (Figure 21). Discard the clip.
Reinstall and tighten the bolt to 11.5 ft.lbs. (15.6 N-m).
Cleaning of Actuator Housing
E.
Cleaning of Actuator Housing (Omit if Actuator was Replaced)
Use a suitable, clean container to drain brake fluid and contaminants in the following steps:
