Grand Wagoneer V8-360 5.9L VIN 7 2-bbl (1989)
M.
Reinstall Window Washer Reservoir
1.
Connect hoses and wires to the window washer reservoir. The front and rear circuits are interchangeable so check the operation of the
washers and correct as needed before mounting the reservoir.
2.
Install reservoir to the inner fender panel.
3.
Refill the reservoir with window washer fluid.
Road Test Vehicle
N.
Road Test Vehicle
1.
Turn the ignition key on.
2.
Make sure that the red and yellow brake system indicator lights go off after the system self-test. This indicates normal system operation.
3.
With the key still on, wait for five minutes without applying the brakes. The pump should not restart during this time.
4.
If one or both indicator lights stay on, a system fault is present. Also, if the pump restarts during the five minute period a fault code may
be generated. Use the DRB II to identify any ABS system faults and correct them before road testing the vehicle.
5.
After ensuring that the ABS brake system is functioning properly, clear all stored faults from the electronic control unit (ECU).
6.
Road test the vehicle. During the road test make several "normal" stops and several stops during which the anti-lock system cycles.
Check for proper pedal feel and brake operation.
7.
Check the system status again following the road test using the DRB II.
Any faults generated during the road test should be diagnosed and corrected as necessary.
8.
Clear any such fault codes from the ECU after correction.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use one of the following labor operation numbers and time allowances:
Labor Operation
Time
Number
Allowance
Replace ABS low pressure hose, clean
05305282
3.0 Hours
and rebuild or replace actuator,
inspect both front brake hoses
and road test ABS system
Replace ABS low pressure hose, clean
05305283
3.3 Hours
and rebuild or replace actuator,
replace one or both front brake hoses
and road test ABS system
Add the cost of parts used plus applicable dealer allowance to your claim.
Parts Return and Vehicle Not Available
Parts Return
Removed piston assemblies and (as applicable) actuator housings must be returned to the Warranty Material Return Center. It is not necessary to return
brake hoses.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing and material return instructions.
