Grand Wagoneer V8-360 5.9L VIN 7 2-bbl (1989)
12. Move the glass toward the rear of the door.
13. Rotate the glass 90~.
14. Guide the glass between the inner and outer door panels and out of the door.
REAR DOOR WINDOW INSTALLATION
1. Position the door glass in the lower section of the door panel.
2. Position the door glass in the front slide channel and push the division channel over the glass.
3. Align the glass with the lift bracket and install the glass attaching screws and plastic nuts.
4. Position the vent window in the door and install the vent frame screws.
5. Install the upper slide channel.
6. Install the inner and outer belt weatherstrip.
7. Install the division channel lower attaching bracket.
8. Install the glass stop bracket.
9. Check window operation.
10. Install the water shield and door trim panel.
REAR VENT WINDOW REMOVAL
1. Remove the door glass.
2. Apply a soap solution under the vent weatherstrip and along the inner and outer door panels.
3. Slide the vent assembly forward to the center of the door glass opening.
4. Push the vent assembly down through the opening between the inner and outer door panels to disengage the assembly from the upper door frame.
5. Lower the top of the vent assembly down to clear the upper door frame.
6. Pull the vent assembly straight up until the weatherseals are clear of the door panel and the vent assembly can be rotated.
7. Rotate the assembly to position the lower attaching bracket on the channel and pull the assembly up and out between the panels.
REAR VENT WINDOW INSTALLATION
1. Install the vent assembly in the door.
2. Engage the vent assembly in the upper door frame and slide the vent into position.
3. Install the attaching hardware.
4. Install the door glass.
