Grand Wagoneer V8-360 5.9L VIN 7 2-bbl (1989)
INSTRUCTIONS FOR USE
1.
Thoroughly clean and dry the area(s) to be bonded with Mopar Brake and Carburetor Cleaner (PN 4318037) or equivalent, or use a swab soaked
with isopropyl alcohol.
2.
Carefully apply Mopar Bond All Gel to one surface. Use only one drop per square inch of surface. Bonding will not take place if too much
adhesive is used.
3.
Press parts together immediately and apply pressure for 15 seconds, or until bond sets. Mopar Bond All Gel works with humidity. In extremely
low humidity conditions, bonding may take slightly longer.
SUGGESTED APPLICATIONS FOR MOPAR BOND ALL GEL
Securing Vinyl Trim
Dashboard Accessories
Repair of Torn Vinyl Upholstery
Attachment of Small Plastic Parts
Rubber Impact Strips
Securing Weather Stripping
Attachment of Plastic Knobs to Steel Shafts
Mopar Bond All Gel will work with the following materials:
Metals
Rubber
Leather
Wood
Plastics
Laminated Plastic
Paper
Textiles
APPLICATIONS NOT RECOMMENDED
Rear View Mirror Buttons
Styrofoam
Polyethylene
Glass Bonding
Foam Rubber
Polypropolene
DO NOT USE IN AREAS EXCEEDING 200~F.
Silicone Windshield and Glass Sealer
MOPAR SILICONE WINDSHIELD AND GLASS SEALER (PN 4467708)
Mopar Silicone Windshield and Glass Sealer is a clear flowable sealant for repair of water and air leaks. This material will flow into leaks like water, but
dries to a tough waterproof silicone seal. It forms a flexible, tough, clear seal resistant to extreme temperatures, vibration, shock, and most chemicals.
INSTRUCTIONS FOR USE
1.
Locate source of the leak. Refer to Windnoise and Waterleaks Diagnosis Booklet (Publication #81-699-9008) for diagnostic procedures.
2.
Clean and dry the area to be sealed.