Liberty 2WD L4-2.4L VIN 1 (2005)
8. Seat dust boot in caliper with Installer Tool C-4842 and Tool Handle C-4171 (Fig. 28).
9. Replace caliper bleed screw if removed.
INSTALLATION
1. Install caliper (1) to the caliper adapter.
2. Coat the caliper mounting slide pin bolts (2) with silicone grease. Begin with the bolt closet to the bleeder screws (top), Then install and tighten
the bolts to 15 Nm (11 ft. lbs.).
3. Install the brake hose banjo bolt (4) if removed (Fig. 29).
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
4. Install the brake hose (3) to the caliper (1) with new seal washers and tighten fitting bolt to 31 Nm (23 ft. lbs.).
5. Remove the prop rod from the vehicle.
6. Bleed the base brake system.
7. Install the wheel and tire assemblies.
8. Remove the supports and lower the vehicle.
9. Verify a firm pedal before moving the vehicle.
