Liberty 2WD L4-2.4L VIN 1 (2005)
5. Install the brake hose banjo bolt if removed (Fig. 31).
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
6. Install the brake hose to the caliper with new seal washers and tighten fitting bolt to 31 Nm (23 ft. lbs.).
7. Remove the prop rod from the vehicle.
8. Bleed the base brake system.
9. Install the wheel and tire assemblies.
10. Remove the supports and lower the vehicle.
11. Verify a firm pedal before moving the vehicle.
