Liberty 2WD V6-3.7L (2008)
Ultrasonic Sensor: Service and Repair
Removal
Receiver
RECEIVER
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console from the headliner. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Overhead Console -
Removal.
3. Locate the intrusion sensor receiver (1) in the mounting bracket (4) on the right front corner of the overhead console housing (3).
4. Disconnect the take out of the overhead wire harness from the connector receptacle (5) on the rearward end of the receiver housing.
5. Release the three latch features (2) of the mounting bracket and disengage the receiver from the bracket.
Transmitter
TRANSMITTER
1. Disconnect and isolate the battery negative cable.
2. Pull the bezel (1) straight down from the headliner (3) to unsnap it from the transducer housing (2) of the intrusion sensor transmitter. Be certain to
take the appropriate precautions not to soil or damage the headliner.
3. Remove the trim from the upper liftgate opening. See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Headliner
Molding/Removal.
4. Partially remove the quarter trim panel from both upper D-pillars. See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Console Shifter Bezel - Removal.