Liberty 2WD V6-3.7L (2008)
Alarm Module: Service and Repair
Installation
INSTALLATION
1. Position the intrusion module (1) onto the left inner D-pillar (3).
2. Install the two plastic push-in fasteners (4) that secure the module to the inner D-pillar.
3. Reconnect the take out of the body wire harness (2) to the connector receptacle on the forward-facing side of the module.
4. Reinstall the trim onto the inside of the left inner D-pillar. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Console
Shifter Bezel - Installation.
5. Reconnect the battery negative cable.
