Liberty 2WD V6-3.7L (2008)
Rear Bumper Cover / Fascia: Service and Repair
Rear Bumper Fascia Foam
Removal
REMOVAL
1. Remove the rear fascia, See: Rear Fascia - Removal.
2. Remove the four rivets (3) from the rear absorber (2).
3. Unsnap and remove the rear absorber (2) from the body (1).
Installation
INSTALLATION
1. Position the rear absorber (2) to the body (1) then use hand pressure on the rear absorber until the plastic clips snap into place securing the rear
absorber to the body.
2. Install the four rivets (3) through the rear absorber (2) and into body (1).
3. Install the rear fascia, See: Rear Fascia - Installation.