Liberty 2WD V6-3.7L (2008)
Front Door Exterior Handle: Service and Repair
Front Door Exterior Handle - Installation
INSTALLATION
1. Position the handle on the door and install the front nut and tighten to 4.5 Nm (40 in. lbs.).
2. Install the carrier plate to the door See: Service and Repair/Front Door Carrier Plate - Installation.
NOTE: The door glass must be in the full up position in order to access the rear exterior handle nut. Use light and a magnetic socket on the
rear nut to prevent from dropping the nut into the door assembly.
3. Install the rear nut (1) to the exterior handle and tighten to 4.5 Nm (40 in. lbs.).
