Liberty 2WD V6-3.7L (2008)
NOTE: Using a grease pencil or equivalent, mark location of lid latch (2) on the console lid (3) for installation alignment.
1. Remove the two screws (1) attaching the console lid latch (2) to the console lid (3).
2. Remove the lid latch (2) from the console lid (3).
Installation
INSTALLATION
NOTE: Align the lid latch (2) with the reference marks made during removal.
1. Install the two screws (1) attaching the console lid latch (2) to the console lid (3).
2. Check the adjustment of the lid latch (2) and adjust as necessary by loosening the two screws (1) and moving the lid latch (2) right or left as
needed until the console lid (3) closes properly.
Floor Console Base Tray - Removal
REMOVAL
1. Using a trim stick C-4755 or equivalent, pry the shift bezel out of the floor console.
2. If equipped, remove electrical connectors attached to shift bezel.
