Liberty 2WD V6-3.7L (2008)
Seat Heater: Service and Repair
Heated Seat Element - Removal
REMOVAL
NOTE: Do not remove the factory installed heating elements from the seat cushion (3) or seat back foam. The original element is permanently
attached and cannot be removed without permanent damage. The replacement heating element is designed to be applied directly on top of the
inoperative factory installed heating element.
NOTE: Heated seat cushion shown, heated seat back similar.
1. Disconnect and isolate the battery negative cable.
2. Remove the appropriate seat cushion trim cover, See: Seat Cushion/Service and Repair/Procedures/Seat Cushion - Disassembly or seat back trim
cover, See: Seat Back/Service and Repair/Procedures/Seat Back - Assembly.
3. Disconnect the inoperative heated seat cushion or seat back element electrical connectors (2).
4. Locate the wires leading from the inoperative heating element and cut them off flush with the edge of the original heating element.
