Liberty 2WD V6-3.7L (2008)
Rear Door Weatherstrip: Service and Repair
Weatherstrip - RDB - Inner
Removal
REMOVAL
1. Remove the door trim panel, See: Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair/Rear Door Trim Panel -
Removal.
2. Rotate the inner belt molding outboard while pulling up to disengage the retention tabs.
Installation
INSTALLATION
1. Press the belt molding onto the trim panel flange starting at the rear and working forward.
2. Install the door trim panel, See: Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair/Rear Door Trim Panel -
Installation.