Liberty 2WD V6-3.7L (2008)
Rear Door Weatherstrip: Service and Repair
Rear Door Weatherstrip
Removal
REMOVAL
1. Open the rear door.
2. Remove weatherstrip from the body mount flange.
Installation
INSTALLATION
NOTE: Position the seal to the bottom of the door opening, with bulb facing outboard, starting the installation at the center of the lower flange.
Press the seal onto the sill flange and work around the perimeter of the door opening until fully seated. Work 1/2 the way around and then start
at the other end of the seal working back, making sure the splice joint has no gap and smoothing the seal to avoid puckers or wrinkles. If in
extreme cold temperatures preheating the weatherstrip to 23.8° C (75° F) may be required to fully seat the weatherstrip.
1. Install the weatherstrip to the body mount flange.
2. Trim the weatherstrip if necessary, and connect the ends together along the flange.